Electronics Line iConnect User Manual page 14

Service Call Button
The Service Call button enables you to contact the monitoring
service and talk to an operator.
To initiate a service call, press and hold down the Service Call
button for a few seconds.
Vocal Message Recording and Playback
Using Message Play and Message Record buttons on the LED
Top Cover you can record a short message that may be played
back later by another user. When there is a new message
waiting, the Message Play button is flashing fast.
To play back a recorded message, press the Message
Play button.
To record a message, press the Message Record Button, record your message, then press
the Message Record button again to stop recording. The message is then played back
and saved.
During recording, the Message Record button is lit. When you have 5 seconds
left out of the 20 seconds timeout, the Message Record and the Service Call
buttons backlights flash.
SOS Panic Alarm Activation
Using the LED Top Cover, you can activate an SOS Panic alarm by pressing the Service
Call and Message Play buttons simultaneously.
System and Arming Status LEDs
The System Status indicators provide essential information on the status of the system
such as arm, disarm, alarm and power failure conditions.
OK
LED Status
(Green)
Off
On
Flashing
8
Meaning
System cannot be armed
The system is ready for arming.
Open Zone. Check that the relevant entrances are secured (i.
e. windows and doors are closed and no movement is detected
by the sensors within the protected area).
2. The User Interface
Service Call
Message Play
Message
Record
iConnect User Manual