Electronics Line iConnect User Manual page 42

To delete a message:
1. From the Service menu, select Messages, Delete Message [7023]; OK?
is displayed.
2. Press ; the message is deleted.
The Record and Play options can also be accessed via a convenient shortcut
without needing to enter a valid user code.
To access the Record Message option from Standby mode, press
To access the Play Message option from Standby mode, press
Siren Tests
To test the external wireless siren:
From the Service menu, select WL Siren Test [703]; the wireless siren is
sounded briefly.
To test the built‐in siren:
From the Service menu, select Siren Test [704]; the built‐in siren is
sounded briefly.
Interface Test
The Interface test enables you to check if the speaker, LEDs and LCD are functioning
correctly.
To test the system interface:
From the Service menu, select Interface Test [705]; a short sequence of
chimes are sounded from the speaker, all LEDs flash and the LCD is
tested on all connected LCD keypads.
Walk Test
Walk Test mode enables you to test all the sensors registered to your system without
triggering an alarm.
To initiate Walk Test mode:
1. From the Service menu, select Walk Test [706]; a list of registered sensors
appears.
2. Trigger each sensor; when the system receives a successful transmission
from a sensor, the sensor is removed from the list.
3. When all the sensors are removed from the list, End Walk Test is displayed.
4. Press to exit Walk Test mode.
Transmitters
The Transmitters menu offers two utilities, TX List and TX Test.
The TX List comprises all registered transmitters and their last reported status.
To view the TX list:
1. From the Service menu, select Transmitters, TX List [7071]; the first
transmitter on the list is displayed.
36
7. Advanced System Operation
then .
then .
iConnect User Manual