Electronics Line iConnect User Manual page 3

Quick Reference Guide
Function
ARM
INSTANT ARM
DISARM
PANIC
ALARM
FIRE
ALARM
MEDICAL
ALARM
MENU MODE
CHECK TROUBLE
CONDITIONS
SWITCH HA/PGM
UNIT ON
SWITCH HA/PGM
UNIT OFF
SERVICE CALL
FIVE SPEED
DIAL NUMBERS
GLOBAL
CHIME
RECORD
MESSAGE
PLAY
MESSAGE
Press...
OR OR
FULL PART
Hold down this key
until "Instant Arming
OK?" is displayed.
Then Press
[USER CODE]
+
+
+
then [USER CODE]
Use this key scroll
the system trouble
list.
then [HA UNIT #]
then [HA UNIT #]
then
press
and hold
Press this key, then
press and hold the
speed dial number
button.
then
then
then
Additional Information
If One-Key Arming is disabled on the
Control System, enter your user code when
arming.
PERIMETER
The default master code is 1234.
Instant arming cancels the entry delay
after Part or Perimeter arming. This feature
can be enabled by your installer.
.
Entering your user code also silences the
siren in the event of an alarm.
Press these buttons together and hold
them down to generate an alarm.
Use the menu navigation buttons ( / )
until the required menu item is displayed
then press
shortcut (e.g. 21 for Bypass Zones).
Pressing
that may be sounded by the system.
Enter the HA module number in two digits
(e.g. 03, or 30 for PGM).
"Service Call Dialing" is displayed. The
number dialed for the service call is
programmed by your installer.
Numbers 1 to 5 can be programmed by
master access in the menu telephone #
[5.2-5.6].
Use the menu navigation buttons ( / ) to
choose enable or disable, then press
After recording a message, "Message
Waiting" is displayed until the message is
played back.
The Message Center is an optional feature
that is included with certain versions of
iConnect Control System.
iii
. Alternatively, enter the
also silences any trouble tones
.