Arming The System - Electronics Line iConnect User Manual

A common zone is a zone that belongs to both partitions. An alarm is generated from
common zones only if the system has been Fully Armed or both partitions 1 and 2 have
been armed.
In the following example one part of the house is assigned to Partition 1, another part to
partition 2. The common zone is in the corridor that belongs to both partitions. In each
diagram, the protected area is shaded.
Full Armed/ Both
Partitions Armed
The common zone is active,
and the corridor is
protected.
3.4.

Arming the System

Before arming the system, check that all doors and windows are secured so that the
system is ready for arming.
Arming with the Keypad
To arm the system using the front panel/wireless keypads:
Press one of the three arming keys. In a partitioned system, press Part
Arming key for partition 1 arming and Perimeter Arming key for
partition 2 arming. The exit delay begins to count down. At the end of
the exit delay, the system is armed.
Wireless Terminal EL‐2724 does not support partitioning.
Enter your user code if One‐Key arming is disabled.
To arm the system with smartkey (Wireless Terminal), one‐key arming must
be disabled.
Arming with the LCD Keypad
To full arm the system using the LCD keypad:
Press FULL on the keypad; the exit delay begins to count down. At the
end of the exit delay, the system is armed.
To Part or Perimeter arm the system, or to arm one partition in a partitioned system,
using the LCD keypad:
1. Press PART on the keypad.
2. If One‐Key Arming is disabled, enter your user code.
16
Partition 1 or 2 Disarmed.
The common zone is deactivated, and the corridor is disarmed.
Now either user can access his partition through the corridor.
3. Arming and Disarming
iConnect User Manual