Magnet mounting
The S3100V2-8TP-PWR-EI supports magnet mounting. Follow these steps to complete magnet mounting:
As shown in
Step1
hole at the center of the magnet, fasten it to a blind nut in the dent of the switch bottom, and make sure
that the magnet and the switch are closely fastened.
CAUTION:
Remove the rubber pads, if any, from the switch.
•
•
Use four magnets to ensure reliable installation of the switch.
Attach the magnet-mounted switch to the specified location. Do not get your fingers stuck between.
Step2
Figure 36 Magnet mounting
(1) Blind nut in the dent of the switch bottom
CAUTION:
Do not apply magnet mounting to devices not meeting the installation requirement. Otherwise, a falloff
•
or bodily injury may occur.
•
Put the switch at a stable place free from vibrations or shocks and avoid installing the switch at a high
place because bodily injury or device damage may occur in case of a falloff; in the case of poor surface,
magnet mounting may not be reliable.
Avoid frequently moving the desk-mounted switch because such movements may damage the surface
•
coating.
Fix the external cables firmly to avoid falloff, which may result in bodily injuries or device damage.
•
•
To mount the switch vertically, make sure the network interfaces of the switch face downwards.
Keep magnetic cards away from the magnets to avoid erasure of any information.
•
Keep computers and monitors that are easily influenced by magnetic fields away from the magnets.
•
Otherwise, faults may occur to these electronic devices.
Figure
36, use a Phillips screwdriver to pass the countersunk head screw through the round
(2) Magnet
27
(3) M3*6 countersunk head screw