Magnet-Mounting The Switch; Magnet-Mount Kit - H3C S5120-SI Installation Manual

Figure 17 Installing a wall anchor in the wall
NOTE:
When you fasten the screw into the expansion anchor, the front end of the anchor expands to
press against the hole so that the screw can be secured to the wall.
Align the two installation holes in the bottom of the switch with these two screws and hang the
4.
switch on the screws, as shown in
Make sure the Ethernet ports of the switch face downwards and the two sides with ventilation
holes are vertical to the ground.
Figure 18 Wall-mounting the switch
(1) Installation hole

Magnet-mounting the switch

The S5120-9P-SI, S5120-9P-PWR-SI, and S5120-9P-HPWR-SI switches support magnet mounting.
You can use magnet-mount kits to attach the switch to a steel desktop or wall.

Magnet-mount kit

A magnet-mount kit includes a permanent magnet and a M3*6 countersunk head screw, as shown
in Figure 19. Four magnet-mount kits are required for magnet-mounting the switch.
Figure 18.
1
12