Magnet Mounting - H3C S3100-8C-Sl Quick Start Manual

Quick Start (For Japan)
H3C S3100 Series Ethernet Switches

3.1.4 Magnet Mounting

The following four models support magnet mounting:
S3100-8TP-EI-W
S3100-8TP-PWR-EI
S3100-16TP-EI-W
S3100-16TP-PWR-EI
I. Introduction to magnetic accessories
A set of magnetic mounting accessories consists of one
permanent magnets and one M3*6 countersunk head screws, as
shown in Figure 3-17. Four sets of magnetic mounting accessories are
needed for each S3100 switch.
(2)
(1) Permanent magnet
Figure 3-17 Magnets and countersunk head screws
II. Installation procedure
Follow these steps to complete magnet mounting:
1) As shown in Figure 3-18, use a Phillips screwdriver to pass
the countersunk head screw through the round hole at the
center of the permanent magnet, fasten it to a blind nut in the
(1)
(2) M3*6 countersunk head screw
3-20
Chapter 3 Installation