Installing the switch in a liquid-cooled rack
Rack-mounting procedures at a glance
Figure2-2 Rack-mounting procedure
Determine the installation
position (near the power
module side or port side)
for the mounting brackets
Rack-mounting requirements
Figure2-3 LS-6850-56HF-CP chassis dimensions (mounting brackets installed at the port
side)
(1) Power module handle
Figure2-4 LS-6850-56HF-CP chassis dimensions (mounting brackets installed at the power
module side)
(1) Power module handle
NOTE:
For more information about the liquid-cooled rack, see H3C Cold Plate-Based Liquid-Cooling
System User Guide.
Table2-1 Distance requirements between the front and rear rack posts
Switch model
LS-6850-56HF-CP
Attach the
Attach the chassis
mounting brackets
rails to both sides of
to both sides of
the switch
the switch
Distance between the
Installation
front and rear rack
method
posts
Extended
314 to 720 mm (12.36 to
mounting
28.35 in, mounting
brackets and
brackets installed at the
short slide rails
port side)
2-3
Connect the
grounding cable
to a grounding
point
(2) Mounting bracket
(2) Mounting bracket
Rack requirements
A minimum of 800 mm (31.50 in) in
depth (recommended).
•
A minimum of 130 mm (5.12 in)
Attach the
Install the
slide rails to
switch in the
the rack
rack