Installing An Sfp Transceiver Module; Connecting An Optical Fiber Connector To An Sfp Transceiver Module - H3C S3100V2 Series Installation Manual

Installing an SFP transceiver module

NOTE:
This section only briefly describes the installation and operation guidelines for an SFP transceiver module.
For more information, see the
Follow these steps to install an SFP transceiver module:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded.
Step1
Unpack the SFP transceiver module. Do not touch the golden finger of the module.
Step2
Pivot the clasp of the transceiver module up so that it catches a knob on the top of the module.
Step3
Squeezing both sides of the module, gently push the module into the slot until it has firm contact with the
Step4
slot (you can feel that the top and bottom spring tabs catch in the slot), as shown in
Figure 56 Install an SFP transceiver module
CAUTION:
Do not remove the dust plug on the SFP transceiver module before installing it.
•
• Remove the fibers, if any, from the SFP transceiver module before installing it.
Connecting an optical fiber connector to an SFP transceiver
module
NOTE:
For more information about optical fibers and fiber connectors, see the
Switches Pluggable Modules Manual
The SFP transceiver modules of the S3100V2 Switch Series use LC connectors, as shown in
H3C Pluggable SFP/SFP+/XFP Transceiver Modules Installation Guide
.
44
Figure 56.
H3C Low End Series Ethernet
Figure
.
57.