Replacing A Gpu Module At The Server Rear; Replacing An Ethernet Adapter - H3C UniServer R6900 G3 User Manual

Figure 7-29 Removing a GPU module
Install a new GPU module. For more information, see
7.
module."
Install the compute module access panel. For more information, see
8.
module access
Install the compute module. For more information, see
9.
10. Install the removed security bezel. For more information, see
11. Connect the power cord. For more information, see
12. Power on the server. For more information, see

Replacing a GPU module at the server rear

Power off the server. For more information, see
1.
Disconnect external cables from the riser card, if any.
2.
Remove the rear riser card and the GPU module. For more information, see
3.
card and PCIe module at the server
Install a new GPU module to the riser card and install the riser card. For more information, see
4.
"Installing riser cards and PCIe modules at the server
Reconnect the external cables to the riser card.
5.
Connect the power cord. For more information, see
6.
Power on the server. For more information, see
7.

Replacing an Ethernet adapter

WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
panel."
rear."
"Installing a GPU module in a compute
"Installing a compute
"Connecting the power
"Powering on the
"Powering off the
rear."
"Connecting the power
"Powering on the
7-24
"Replacing a compute
module."
"Installing the security
cord."
server."
server."
"Replacing a riser
cord."
server."
bezel."