Replacing The System Battery - H3C UniServer R6900 G3 User Manual

Remove the security bezel, if any. For more information, see
2.
Remove the compute module. For more information, see
3.
Remove the compute module access panel. For more information, see
4.
module access
Remove the riser card and PCIe module in the compute module. For more information, see
5.
"Replacing the riser card and PCIe module in a compute
Remove air baffles in the compute module. For more information, see
6.
compute
Open the DIMM slot latches and pull the DIMM out of the slot, as shown in
7.
Figure 7-43 Removing a DIMM
Install a new DIMM. For more information, see
8.
Install the removed air baffles in the compute module. For more information, see
9.
baffles in a compute
10. Install the removed riser card and PCIe module in the compute module. For more information,
see "Installing a riser card and a PCIe module in a compute
11. Install the compute module access panel. For more information, see
module access
12. Install the compute module. For more information, see
13. Install the removed security bezel. For more information, see
14. Connect the power cord. For more information, see
15. Power on the server. For more information, see
During server startup, you can access BIOS to configure the memory mode of the newly
installed DIMM. For more information, see the BIOS user guide for the server.
Verifying the replacement
For information about the verification method, see

Replacing the system battery

WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
panel."
module."
module."
panel."
"Removing a compute
module."
"Installing DIMMs."
"Installing a compute
"Connecting the power
"Powering on the
"Installing DIMMs."
7-38
"Replacing the security
module."
"Replacing a compute
"Replacing air baffles in a
Figure
"Replacing air
module."
"Replacing a compute
module."
"Installing the security
cord."
server."
bezel."
7-43.
bezel."