Setting The Ip Configuration - NetApp StorageGRID SG5700 Series Hardware Installation And Maintenance Manual

42 | Hardware Installation and Maintenance Guide for SG5700 Appliances

Setting the IP configuration

You use the StorageGRID Appliance Installer to configure the IP addresses and routing information
used for the appliance Storage Node on the StorageGRID Grid, Admin, and Client Networks.
About this task
You must either assign a static IP for the appliance on each connected network or assign a permanent
lease for the address on the DHCP server.
Additionally, if you want to change the link configuration of a StorageGRID appliance, see
"Changing the link configuration of the E5700SG controller."
Steps
1. From the menu bar of the StorageGRID Appliance Installer, click Configure Networking > IP
Configuration.
The IP Configuration page appears. This example shows the Grid Network section of the page
with IP Assignment set to DHCP.
2. Configure the Grid Network.
a. If you plan to use a static IP address for the appliance on the Grid Network, select Static.
b. Enter the static IPv4 address, using CIDR notation.
c. Enter the gateway.
If your network does not have a gateway, re-enter the same static IPv4 address.