Setting The Ip Configuration - NetApp StorageGRID Webscale SG5700 Series Hardware Installation And Maintenance Manual

5. When you are satisfied with your selections, click Save.
You might lose your connection if you made changes to the network or link you are
Note:
connected through. If you are not reconnected within 1 minute, re-enter the URL for the
StorageGRID Webscale Appliance Installer using one of the other IP addresses assigned to the
appliance:
http://E5700SG_Controller_IP:8080
Related concepts
10/25-GbE port connections for the E5700SG controller

Setting the IP configuration

You use the StorageGRID Webscale Appliance Installer to configure the IP addresses and routing
information used for the appliance Storage Node on the StorageGRID Webscale Grid, Admin, and
Client Networks.
About this task
You must either assign a static IP for the appliance on each connected network or assign a permanent
lease for the address on the DHCP server.
If the virtual nodes in your grid are deployed on VMware, you must use a static IP address
Note:
for the appliance on the Grid Network.
Configuring the hardware | 47
on page 17