NetApp StorageGRID SG5700 Series Hardware Installation And Maintenance Manual page 21

Information needed
Admin Network enabled
Network bond mode
Switch port for port 1
Switch port for port 2 (Active-Backup network
bond mode only)
DHCP-assigned IP address for management
port 1, if available after power on
Note: If the Admin Network includes a
DHCP server, the E5700SG controller
displays the DHCP-assigned IP address on its
seven-segment display after it boots up. You
can also determine the DHCP-assigned IP
address by using the MAC address to look up
the assigned IP.
Static IP address you plan to use for the
appliance Storage Node on the Admin Network
Note: If your network does not have a
gateway, specify the same static IPv4 address
for the gateway.
Admin Network subnets (CIDR)
Table 3: Information needed to connect and configure the 10/25-GbE ports on the
E5700SG controller
The four 10/25-GbE ports on the E5700SG controller connect to the StorageGRID Grid Network and
Client Network.
See "10/25-GbE port connections for the E5700SG controller" for more information about
Note:
the options for these ports.
Information needed
Link speed
Note: If you select 25 GbE, you must install
SPF28 transceivers. Auto-negotiation is not
supported, so you must also configure the
ports and the connected switches for 25GbE.
Port bond mode
Preparing for installation | 21
Your value
Choose one:
• No
• Yes (default)
Choose one:
• Independent
• Active-Backup
• IPv4 address (CIDR):
• Gateway:
• IPv4 address (CIDR):
• Gateway:
Your value
Choose one:
• 10 GbE (default)
• 25 GbE
Choose one:
• Fixed (default)
• Aggregate