Verifying Network Connections - NetApp StorageGRID SG5700 Series Hardware Installation And Maintenance Manual

44 | Hardware Installation and Maintenance Guide for SG5700 Appliances
e. Confirm that the list of Admin Network subnets is correct.
You must verify that all subnets can be reached using the gateway provided above.
Note: The default route cannot be made to use the Admin Network gateway.
• To add a subnet, click the insert icon
• To remove an unused subnet, click the delete icon
f. Click Save.
4. Configure the Client Network.
This section of the page appears if the Client Network is enabled on the Link Configuration page.
a. If you plan to use a static IP address for the appliance on the Client Network, select Static.
b. Enter the static IPv4 address, using CIDR notation.
c. Click Save.
d. Confirm that the IP address for the Client Network gateway is correct.
Note: If the Client Network is is enabled, the default route is displayed. The default route
uses the Client Network gateway and cannot be moved to another interface while the Client
Network is enabled.
e. Click Save.
Related tasks
Changing the link configuration of the E5700SG controller

Verifying network connections

You should confirm you can access the StorageGRID networks you are using from the appliance. To
validate routing through network gateways, you should test connectivity between the StorageGRID
Appliance Installer and IP addresses on different subnets.
Steps
1. From the menu bar of the StorageGRID Appliance Installer, click Configure Networking > Ping
Test.
The Ping Test page appears.
to the right of the last entry.
.
on page 71