NetApp StorageGRID SG5700 Series Hardware Installation And Maintenance Manual page 73

If possible, use the URL containing the IP address of the appliance's Admin Network
Note:
port.
Accessing
Note:
management port.
g. Confirm that the appliance is in maintenance mode by noting the maintenance mode message
on the StorageGRID Appliance Installer home page.
2. Select Configure Networking > Link Configuration from the menu.
3. Make the desired changes to the link configuration.
For more information on the options, see "Configuring network links."
4. When you are satisfied with your selections, click Save.
You might lose your connection if you made changes to the network or link you are
Note:
connected through. If you are not reconnected within 1 minute, re-enter the URL for the
StorageGRID Appliance Installer using one of the other IP addresses assigned to the appliance:
https://E5700SG_Controller_IP:8443
5. From the StorageGRID Appliance Installer, select Configure Networking > Ping Test.
6. Use the Ping Test tool to check connectivity to IP addresses on any networks that might have been
affected by the link configuration changes you made in step
In addition to any other tests you choose to perform, confirm that you can ping the grid IP address
of the primary Admin Node, and the grid IP address of at least one other Storage Node. If
necessary, correct any link configuration issues.
7. Once you are satisfied that your link configuration changes are working, return the appliance to
normal operating mode:
a. From the StorageGRID Appliance Installer, select Advanced > Reboot Controller.
https://169.254.0.1:8443
Maintaining the SG5700 appliance | 73
requires a direct connection to the local
3
.