ALGE-Timing TdC 8000 Manual page 87

Input of penalty points:
Pre-adjusted value:
the penalty points (display (8), left field). Change pointer with cursor key if necessary.
If you press <ENTER> (keyboard 15) it will increase the penalty points by the pre-adjusted value
(menu 35).
Variable value: The pointer between the penalty points and penalty seconds must point to the
penalty points (display (8), left field). Change pointer with cursor key if necessary.
Input penalty points and confirm with <ENTER> (keyboard 15).
Changing of total points: The pointer between the penalty points and penalty seconds must point to
the penalty points (display (8), left field). Change pointer with cursor key if necessary.
Input total points and confirm with <INPUT> (keyboard 15).
Penalty time for obstacle set up (stage 1):
If a hours refuses to jump a obstacle and the obstacle drops, it is necessary to set up the obstacle
again. For the set up you must stop the time (time-out) by pressing the handswitch (channel 9).
Normally a penalty time is given to the rider. This penalty time will be added to the clear round time
after he passes the finish. When the obstacle is set up press the handswitch again to finish the
time-out.
Press handswitch (channel 9).
The time in the display (7) must stop.
The pointer must point to the penalty seconds (right field of display 8).
Input penalty seconds with keyboard (15).
Confirm penalty seconds with <ENTER>.
If you want to input penalty points as well change with cursor key the pointer to the penalty
points (left field of display 8).
Press handswitch (channel 9) when the obstacle is set up.
The time in display (7) must run.
Penalty points from time violation (stage 1):
The penalty points from the time violation and obstacle set up will be automatically calculated, if you
input the maximum allowed time (menu 39, parcour time). The actual points you can always see in
the info display (6). The printer and display board will update the score by pressing <F3>.
Adding of penaly seconds (stage 1):
The penaly seconds for obstacle set up must be added for the printer and display board after the
finish. First you must print and show the result without penalty seconds. If you press the key <F3> it
will add the penalty seconds and all data will be new calculated. It will print the final score and show
it on the display board.
Penalty time for obstacle set up (stage 2):
If a hours refuses to jump a obstacle and the obstacle drops, it is necessary to set up the obstacle
again. For the set up you must stop the time (time-out) by pressing the handswitch (channel 9).
Normally a penalty time is given to the rider. This penalty time will be added to the clear round time
after he passes the finish. When the obstacle is set up press the handswitch again to finish the
time-out.
Press handswitch (channel 9).
The time in the display (7) must stop.
The pointer must point to the penalty seconds (right field of display 8).
Input penalty seconds with keyboard (15).
Confirm penalty seconds with <ENTER>.
Version: E-01-08-08
TdC 8000 for Equestrian
The pointer between the penalty points and penalty seconds must point to
Page 87
Page 87