ALGE-Timing TdC 8000 Manual page 60

Input of penalty seconds for obstacle drop:
Pre-adjusted value:
seconds for obstacle setup must point to the left field (display (8)). Change pointer with cursor key if
necessary.
If you press <ENTER> (keyboard 15) it will increase the penalty seconds for obstacle drop by the
pre-adjusted value (menu 35).
Variable value: The pointer between the penalty seconds for obstacle drop and penalty seconds
for obstacle setup must point to the left field (display (8)). Change pointer with cursor key if
necessary.
Input penalty seconds for obstacle drop and confirm with <ENTER> (keyboard 15).
Changing of total points: The pointer between the penalty seconds for obstacle drop and penalty
seconds for obstacle setup must point to the left field (display (8)). Change pointer with cursor key if
necessary.
Input total penalty seconds for obstacle drop and confirm with <INPUT> (keyboard 15).
Penalty time for obstacle set up:
If a hours refuses to jump a obstacle and the obstacle drops, it is necessary to set up the obstacle
again. For the set up you must stop the time (time-out) by pressing the handswitch (channel 9).
Normally a penalty time is given to the rider. This penalty time will be added to the clear round time
after he passes the finish. When the obstacle is set up press the handswitch again to finish the
time-out.
Press handswitch (channel 9).
The time in the display (7) must stop.
The pointer must point to the penalty seconds (right field of display 8).
Input penalty seconds with keyboard (15).
Confirm penalty seconds with <ENTER>.
If you want to input penalty points as well change with cursor key the pointer to the penalty
points (left field of display 8).
Press handswitch (channel 9) when the obstacle is set up.
The time in display (7) must run.
Penalty time from time violation:
The penalty time from the time violation will be automatically calculated, if you input the maximum
allowed time (menu 38, parcour time). If you have also a penalty time from obstacle set up, then this
time will be added when pressing the <F3> key after the rider finish.
Recalculation of the Total Time:
The penalty seconds for obstacle set are added immediately to the run time. Penalty seconds for
obstacle drop and time violation are added after the rider finish. When you press the <F3> key it
adds all up and prints the total time.
Function of the keyboard:
clear Start Time
recall last Start Time that was cleared ALT + CLEAR
clear Finish Time
recall last Finish Time that was cleared
block Start Time
ignore Start Time
block Finish Time
ignore Finish Time
manipulate Start Time
manipulate Finish Time
manipulate Penalty Time (obstacle drop)
manipulate Penalty Time (obstacle set up)
Timing Channels:
Version:E-00-08-08
TdC 8000 for Equestrian
The pointer between the penalty seconds for obstacle drop and penalty
Keyboard 9 and 14
CLEAR
BLOCK
ALT + BLOCK
INPUT
c0 = Start Channel
c1 = Finish Channel
Keyboard 15 and 14
CLEAR
ALT + CLEAR
BLOCK
ALT + BLOCK
INPUT
Points, than INPUT
Points, than INPUT
c2 to c8 .... no function
c9 = Countdown and Time-out
Page 60
Page 60