ALGE-Timing TdC 8000 Manual page 34

Rank for Finish Time:
For each run time (or total time) it shows the rank on display (7) and on the display board. It shows
the rank as long as you have the display time adjusted (see menu 4).
Menu 11: FINISH RANK
Save with: ENTER
Pre adjusted value:rank for finish time is on
Print Menus:
Whenever you change an ALGE adjustment in the menus it prints the new adjustment (e.g. during
the switch on procedure). If you select "PRINT MENUS = OFF" it will not print the menu adjust-
ments. Also changes made in the main menu wont be printed.
on = <F1>
off = <F2>
Menu 15: PRINT MENUS
Save with: ENTER
Pre adjusted value:print menu adjustments
Printer Linefeed:
The printer can print after each paragraph linefeed (e.g. two linefeed to have the printed lines above
the cuter). You can adjust between 1 and 9 linefeeds. If you use zero (ALGE adjustment) it prints in
every line.
Menu 16: PRINTER LINEFEED = 0
Save with: ENTER
Pre adjusted value:Printer prints in every line (printer linefeed = 0)
RS 232 Baudrate:
You can adjust the baud rate of the RS 232 interface (23): 2400, 4800, 9600, or 19200 baud.
Menu 17: RS-232 BAUDRATE
Save with: ENTER
Pre adjusted value:
Version:E-00-08-08
TdC 8000 for Equestrian
Menu 11: FINISH RANK = ON
confirm with <ENTER>
Menu 15: PRINT MENUS = ON
it prints the menu adjustments
it does not print the menus adjustments
Menu 16: PRINTER LINEFEED = 0
Menu 17: RS-232 BAUDRATE = 9600 Bd
9600 Baud
shows rank
ON< F1
no rank shown
OFF F2
confirm selection with
<ENTER>
print menu
ON< F1
do not print menu
OFF F2
confirm selection with
<ENTER>
input amount of linefeed
confirm selection with
<ENTER>
Select with <F1>
2400 Bd F1
Select with <F2>
4800 Bd F2
Select with <F3>
9600 Bd F3
confirm selection with
19200 Bd F4
<ENTER>
Page 34
Page 34