ALGE-Timing TdC 8000 Manual page 33

Start Delay Time:
You can adjust the start delay time between 0.00 to 9.99 seconds.
To input the start delay time use the finish keyboard (15). Confirm the adjusted time with <ENTER>.
Pre adjusted value: 1,00 s
Menu 1: DELAY TIME START = 1.00 s
Save with: ENTER
Finish Delay Time:
You can adjust the finish delay time between 0.00 and 9,99 seconds.
To input the finish delay time use the finish keyboard (15). Confirm the adjusted time with <EN-
TER>.
Pre adjusted value: 0,30 s
Menu 2: DELAY TIME FINISH = 0.30 s
Save with: ENTER
Seconds Mode
Normally is the seconds mode off. If you use the seconds mode you have no minutes. This means
the clock jumps at 60 seconds not to 1 minute, but continues to count 61, 62, 63, etc. This mode is
necessary for some sports.
Menu 3: SECONDS MODE
Save with: ENTER
Pre adjusted value:
Running Tenth:
The finish display (7) and the interface "display board" (24) can output the running tenth second (the
ALGE-display-board cannot show the running tenth second). The running tenth second is important
to feed a video generator (for TV).
on = <F1>
off = <F2>
Menu 9: RUNNING TENTH
Save with: ENTER
Pre adjusted value:running tenth seconds are on
Version: E-01-08-08
TdC 8000 for Equestrian
Menu 2:
Menu 3:
Seconds mode off
Menu 9:
running tenth second is on
running tenth second is off
confirm with <ENTER>
Menu 1: DELAY TIME START = 1.00 s
input delay time
confirm delay time with
<ENTER>
DELAY TIME FINISH = 0,30 s
input delay time
confirm delay time with
<ENTER>
SECONDS MODE = OFF
F1 Seconds mode activated
ON
OFF< F2
Running Tenth = ON
ON F1
OFF< F2
Page 33
Normal time
running tenth is on
running tenth is off
Page 33