ALGE-Timing TdC 8000 Manual page 78

Input of penalty points:
Pre-adjusted value:
the penalty points (display (8), left field). Change pointer with cursor key if necessary.
If you press <ENTER> (keyboard 15) it will increase the penalty points by the pre-adjusted value
(menu 35).
Variable value: The pointer between the penalty points and penalty seconds must point to the
penalty points (display (8), left field). Change pointer with cursor key if necessary.
Input penalty points and confirm with <ENTER> (keyboard 15).
Changing of total points: The pointer between the penalty points and penalty seconds must point to
the penalty points (display (8), left field). Change pointer with cursor key if necessary.
Input total points and confirm with <INPUT> (keyboard 15).
Penalty time for obstacle set up:
If a hours refuses to jump a obstacle and the obstacle drops, it is necessary to set up the obstacle
again. For the set up you must stop the time (time-out) by pressing the handswitch (channel 9).
Normally a penalty time is given to the rider. This penalty time will be added to the clear round time
after he passes the finish. When the obstacle is set up press the handswitch again to finish the
time-out.
+ Press handswitch (channel 9).
+ The time in the display (7) must stop.
+ The pointer must point to the penalty seconds (right field of display 8).
+ Input penalty seconds with keyboard (15).
+ Confirm penalty seconds with <ENTER>.
+ If you want to input penalty points as well change with cursor key the pointer to the penalty
points (left field of display 8).
+ Press handswitch (channel 9) when the obstacle is set up.
+ The time in display (7) must run.
Penalty points from time violation:
The penalty points from the time violation and obstacle set up will be automatically calculated, if you
input the maximum allowed time (menu 39, parcour time). The actual points you can always see in
the info display (6). The printer and display board will update the score by pressing <F3>.
Adding of penaly seconds:
The penaly seconds for obstacle set up must be added for the printer and display board after the
finish. First you must print and show the result without penalty seconds. If you press the key <F3> it
will add the penalty seconds and all data will be new calculated. It will print the final score and show
it on the display board.
Function of the keyboard:
clear Start Time
recall last Start Time that was cleared ALT + CLEAR
clear Finish Time
recall last Finish Time that was cleared
block Start Time
Ignore Start Time
block Finish Time
ignore Finish Time
manipulate Start Time
manipulate Finish Time
manipulate Penalty Points
manipulate Penalty Time
Timing Channels: c0
c1
Version:E-00-08-08
TdC 8000 for Equestrian
The pointer between the penalty points and penalty seconds must point to
Keyboard 9 and 14
CLEAR
BLOCK
ALT + BLOCK
INPUT
= Start Channel
= Finish Channel
Keyboard 15 and 14
CLEAR
ALT + CLEAR
BLOCK
ALT + BLOCK
Points, than INPUT
Time, than INPUT
c2 to c8 .... no function
c9 = Countdown and Time-out
Page 78
INPUT
Page 78