ALGE-Timing TdC 8000 Manual page 59

Parcour Time 1: Menu 39
It is very important that you adjust the parcour time (the maximum allowed time). If you do not input
the parcour time it will not add penalty seconds for time violation.
Menu 39: PARCOUR TIME 1 = 000.00
Save with: ENTER
Pre adjusted value::
Block Time: Menu 41
As long as the block time is running, it will take every impulse of the finish photocell as a not valid
impulse. This time will be printed only as time of day with a question mark. The time will not be
stopped on the display (7) or display board. Use the block time for events where the rider passes
the finish photocell before he reaches the finish.
Menu 41: BLOCK TIME 1 = 000.00
Save with:: ENTER
Pre adjusted value::
Count Down Time:
You can adjust the count down time between 0 and 6399.99 seconds. The count down time is the
time between the greeting of the judges and the time when the rider must start. It is possible to
show the count down time on a display board (see menu 43). A horn (if connected) honks at the
start and end of the count down.
Menu 43: COUNT DOWN TIME = 000060.00
AUTOMATIKSTART = ON
Save with:: ENTER
Pre adjusted value::
Countdown for Display Board
You can switch off the countdown for the display board. All other functions of the countdown work, if
the countdown for the display board is off.
Menu 45: D-Board Count Down
Save with: ENTER Save and exit with <ENTER>
Pre adjusted value::
Version: E-01-08-08
TdC 8000 for Equestrian
Parcour Time = 000.00
no parcour time is pre adjusted!
Block Time 1 = 000.00
no block time is pre adjusted!
Menu 43 Count Down Time = 000060.00
Count Down Time = 60 seconds
Menu 45
OFF
D-Board Count Down = on
Input the maximum allowed time
Save and exit with <ENTER>
Input the block time
Save and exit with <ENTER>
Input count down time
Automatic Start On or OFF
Save and exit with <ENTER>
D-Board Count Down = ON
output on display board
ON<
no output on display board
Page 59
Page 59