Tcp Modbus; Figure 5.80 Management > Snmp > Snmp Trap; Figure 5.81 Management > Tcp Modbus > Tcp Modbus Settings - Wieland wienet FS8 Series User Manual

5.11.2.4 SNMP Trap
The SNMP Trap page allows you to set the IP address of the node and the SNMP credentials corresponding
to the version that is included in the trap message.
To access this page, click Management > SNMP > SNMP Trap.
Figure 5.80 Management > SNMP > SNMP Trap
The following table describes the items in the previous figure.
Item Description
IP Address Enter the IP address to designate the SNMP trap host.
Name Click the drop-down menu to select a defined community name.
Version Click the drop-down menu to designate the SNMP version credentials (v1 or v2c).
Add Click Add to save the values and update the screen.
The ensuing table for Trap Host Status settings are informational only: No., IP Address, Community Name,
Version and Delete (click to delete the desired IP address).
5.11.3

TCP Modbus

The TCP Modbus function allows for client-server communication between a switch module (server) and a
device in the networking running MODBUS client software (client).
5.11.3.1 TCP Modbus Settings
The TCP Modbus Settings page allows you to configure the modbus function.
To access this page, click Management > TCP Modbus > TCP Modbus Settings.
Figure 5.81 Management > TCP Modbus > TCP Modbus Settings
The following table describes the items in the previous figure.
Item Description
State Click Disabled or Enabled to set the TCP Modbus state.
Time out Enter the value (1 to 86400) to define the timeout period between transport time.
Apply Click Apply to save the values and update the screen.
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018
5 Managing Switch
95