Figure 5.19 L2 Switching > Link Aggregation > Lag Port Settings; Figure 5.20 L2 Switching > Link Aggregation > Lacp Priority Settings - Wieland wienet FS8 Series User Manual

5 Managing Switch
To access this page, click L2 Switching > Link Aggregation > LAG Port Settings.
Figure 5.19 L2 Switching > Link Aggregation > LAG Port Settings
The following table describes the items in the previous figure.
Item Description
LAG Select Click the drop-down menu to select a predefined LAG trunk definition: LAG 1-8.
Enabled Click the radio button to enable or disable the LAG Port.
Speed Click the drop-down menu to select the port speed: Auto, Auto-10M, Auto-100M,
Auto-10/100M, 10M or 100M.
Flow Control Click the radio button to enable or disable the Flow Control for the LAG Port.
Apply Click Apply to save the values and update the screen.
The ensuing table for LAG Port Status settings are informational only: LAG, Description, Port Type, Enable
State, Link Status, Speed, Duplex, FlowCtrl Config and FlowCtrl Status.
5.7.3.4 LACP Priority Settings
The LACP Priority Settings page allows you to configure the system priority for LACP.
To access this page, click L2 Switching > Link Aggregation > LACP Priority Settings.
Figure 5.20 L2 Switching > Link Aggregation > LACP Priority Settings
The following table describes the items in the previous figure.
Item Description
System Priority Enter the value (1-65535) to designate the LACP system priority.
Apply Click Apply to save the values and update the screen.
The ensuing table for LACP Information settings are informational only: System Priority.
50 Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018