Q Vlan; Figure 5.21 L2 Switching > Link Aggregation > Lacp Port Settings - Wieland wienet FS8 Series User Manual

5.7.3.5 LACP Port Settings
Link Aggregation Control Protocol (LACP) provides a method to control the bundling of several physical
ports together to form a single logical channel. By configuring the LACP function, the Switch can negotiate
an automatic bundling of links by sending LACP packets to the peer device (also implementing LACP).
To access this page, click L2 Switching > Link Aggregation > LACP Port Settings.
Figure 5.21 L2 Switching > Link Aggregation > LACP Port Settings
The following table describes the items in the previous figure.
Item Description
Port Select Select a port for the LACP Port Settings. The listed available settings are: Port1-10.
However, the available settings are dependent on the connected LACP device and
may not be listed as displayed in the current figure.
Priority Enter a variable (1 to 65535) to assign a priority to the defined port selection.
Timeout Click the radio button to select a long or short timeout period.
Mode Click the radio button to select the setting mode: Active or Passive.
Apply Click Apply to save the values and update the screen.
The ensuing table for LACP Port Information settings are informational only: Port Name, Priority, Timeout
and Mode.

5.7.4 802.1Q VLAN

The 802.1Q VLAN feature allows for a single VLAN to support multiple VLANs. With the 802.1Q feature
you can preserve VLAN IDs and segregate different VLAN traffic.
The 802.1Q VLAN tag feature encapsulates the 802.1Q VLAN tagging within another 802.1Q VLAN tag.
The outer tag is assigned following the AP group, while the inner VLAN ID is assigned dynamically by the
AAA server.
5.7.4.1 VLAN Management
The management of VLANs is available through the VLAN Settings page. Through this page you can add
or delete VLAN listings and add a prefix name to an added entry.
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018

Active: Enables LACP unconditionally.

Passive: Enables LACP only when an LACP device is detected (default state).
5 Managing Switch
51