Snmp; Figure 5.77 Management > Snmp > Snmp Settings; Figure 5.78 Management > Snmp > Snmp Community - Wieland wienet FS8 Series User Manual

5.11.1.5 LLDP Overloading
To access this page, click Management > LLDP > LLDP Overloading.
The ensuing table for LLDP Overloading settings are informational only: Port, Total (Bytes), Left to Send
(Bytes), Status and Status (Mandatory TLVs, 802.3 TLVs, Optional TLVs and 802.1 TLVs).
5.11.2

SNMP

Simple Network Management Protocol (SNMP) is a protocol to facilitate the monitoring and exchange of
management information between network devices. Through SNMP, the health of the network or status
of a particular device can be determined.
5.11.2.1 SNMP Settings
The SNMP Settings page allows you to set the SNMP daemon state (enabled or disabled).
To access this page, click Management > SNMP > SNMP Settings.
Figure 5.77 Management > SNMP > SNMP Settings
The following table describes the items in the previous figure.
Item Description
State Click Enabled or Disabled to define the SNMP daemon.
Apply Click Apply to save the values and update the screen.
The ensuing table for SNMP Information settings are informational only: SNMP.
5.11.2.2 SNMP Community
The SNMP Community page provides configuration options for the community. SNMP v1 and SNMP v2c
use the group name (Community Name) certification. Its role is similar to the password function. If SNMP
v1 and SNMP v2c are used, you can go directly from the configuration settings to this page to configure
the SNMP community.
To access this page, click Management > SNMP > SNMP Community.
Figure 5.78 Management > SNMP > SNMP Community
The following table describes the items in the previous figure.
Item Description
Community Name Enter a community name (up to 20 characters).
Access Right Click the radio box to specify the access level (read only or read write).
Apply Click Apply to save the values and update the screen.
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018
5 Managing Switch
93