Figure 5.37 L2 Switching > Spanning Tree > Stp Port Settings - Wieland wienet FS8 Series User Manual

Item Description
Force Version Click the drop-down menu to select the operating mode for STP.
Apply Click Apply to save the values and update the screen.
The ensuing table for STP Information settings are informational only: STP, BPDU Forward, PathCost
Method and Force Version.
5.7.9.2 STP Port Settings
The STP Port Settings page allows you to configure the ports for the setting, port's contribution, configure
edge port, and set the status of the BPDU filter.
To access this page, click L2 Switching > Spanning Tree > STP Port Settings.
Figure 5.37 L2 Switching > Spanning Tree > STP Port Settings
The following table describes the items in the previous figure.
Item
Port Select
Admin Enable
Path Cost (0 = Auto)
Edge Port
P2P MAC
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018

STP-Compatible: 802.1D STP operation.

RSTP-Operation: 802.1w operation.

MSTP-Operation: 802.1s operation.
Description
Select the port list to specify the ports that apply to this setting.
Select Enabled or Disabled to setup the admin profile for the STP port.
Select short or long to define the method of used for path cost calculations.
Click the drop-down menu to set the edge port configuration.

No: Force to false state (as link to a bridge).

Yes: Force to true state (as link to a host).
Click the drop-down menu to set the Point-to-Point port configuration.

No: Force to false state.

Yes: Force to true state.
5 Managing Switch
63