Link Aggregation; Figure 5.16 L2 Switching > Port Mirror; Figure 5.17 L2 Switching > Link Aggregation > Load Balance - Wieland wienet FS8 Series User Manual

5 Managing Switch
To access this page, click L2 Switching > Port Mirror.
Figure 5.16 L2 Switching > Port Mirror
The following table describes the items in the previous figure.
Item Description
Session ID Click the drop-down menu to select a port mirroring session from the list. The
number of sessions allowed is platform specific.
Monitor session Click the drop-down menu to enable or disable the session mode for a selected
state session ID.
Destination Port Click the drop-down menu to select the destination port and receive all the traffic
from configured mirrored port(s).
Allow-ingress Click the drop-down menu to select the destination port and receive all the traffic
from configured mirrored port(s).
Sniffer RX Ports Enter the variable to define the RX port.
Sniffer TX Ports Enter the variable to define the TX port.
Apply Click Apply to save the values and update the screen.
The ensuing table for Mirror Status settings are informational only: Session ID, Destination Port, Ingress
State, Source TX Port and Source RX Port.

5.7.3 Link Aggregation

Link Aggregation is a method for combining multiple network connections in parallel in order to increase
throughput beyond the capability of a single connection, and to provide redundancy in case one of the
links should fail.
5.7.3.1 Load Balance
The Load Balancing page allows you to select between a MAC Address or IP/MAC Address algorithm for
the even distribution of IP traffic across two or more links.
To access this page, click L2 Switching > Link Aggregation > Load Balance.
Figure 5.17 L2 Switching > Link Aggregation > Load Balance
48 Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018