Rate Limit; Figure 5.68 Qos > Qos Basic Mode > Port Settings; Figure 5.69 Qos > Rate Limit > Ingress Bandwidth Control - Wieland wienet FS8 Series User Manual

5.10.2.2 Port Settings
The Port Settings page allows you to define a trust state (enabled or disabled) to a listed port.
To access this page, click QoS > QoS Basic Mode > Port Settings.
Figure 5.68 QoS > QoS Basic Mode > Port Settings
The following table describes the items in the previous figure.
Item Description
Port Enter the port number for the QoS basic mode setting.
Trust State Select Enabled or Disabled to set the port's trust state status.
Apply Click Apply to save the values and update the screen.
The ensuing table for QoS Port Status settings are informational only: Port and Trust State.
5.10.3

Rate Limit

Rate Limits features control on a per port basis. Bandwidth control is supported for the following: Ingress
Bandwidth Control, Egress Bandwidth Control and Egress Queue.
5.10.3.1 Ingress Bandwidth Control
The Ingress Bandwidth Control page allows you to configure the bandwidth control for a listed port.
To access this page, click QoS > Rate Limit > Ingress Bandwidth Control.
Figure 5.69 QoS > Rate Limit > Ingress Bandwidth Control
The following table describes the items in the previous figure.
Item Description
Port Enter the port number for the rate limit setup.
State Select Disabled or Enabled to set the port's state status.
Rate (Kbps) Enter the value in Kbps (16 to 1000000) to set the bandwidth rate for the selected port.
Click Apply to save the values and update the screen.
Apply
The ensuing table for Ingress Bandwidth Control Status settings are informational only: Port and Ingress
Rate Limit (Kbps).
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018
5 Managing Switch
87