Figure 4.11 Removing A Terminal Block; Figure 4.12 Installing Dc Wires In A Terminal Block; Figure 4.13 Installing Dc Wires In A Terminal Block - Wieland wienet FS8 Series User Manual

4 Switch Installation
2. Remove the terminal block from the Switch.
3. Insert a small flat-bladed screwdriver in the V1+/V1- wire-clamp screws, and loosen the
screws.
4. Insert the negative/positive DC wires into the V+/V- terminals of PW1. If setting up power
redundancy, connect PW2 in the same manner.

Figure 4.12 Installing DC Wires in a Terminal Block

5. Tighten the wire-clamp screws to secure the DC wires in place.

Figure 4.13 Installing DC Wires in a Terminal Block

28

Figure 4.11 Removing a Terminal Block

Loosening Wire-clamp Screws
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018
Installing DC Wires
Securing Wire-clamp Screws