L2 Switching; Port Configuration; Port Mirror; Figure 5.15 L2 Switching > Port Configuration - Wieland wienet FS8 Series User Manual

5.7 L2 Switching

5.7.1 Port Configuration

Port Configuration describes how to use the user interface to configure LAN ports on the Switch.
To access this page, click L2 Switching > Port Configuration.
Figure 5.15 L2 Switching > Port Configuration
The following table describes the items in the previous figure.
Item Description
Port Click the drop-down menu to select the port for the L2 Switch setting
Enabled Click the radio-button to enable or disable the Port Setting function.
Speed Click the drop-down menu to select the port speed: Auto, Auto-10M, Auto-100M,
Auto-10/100M, 10M or 100M.
Duplex Click the drop-down menu to select the duplex setting: Half or Full.
Flow Control Click the radio button to enable or disable the flow control function.
Apply Click Apply to save the values and update the screen.
The ensuing table for Port Status settings are informational only: Port, Edit (click to enter description),
Enable State, Link Status, Speed, Duplex, FlowCtrl Config and FlowCtrl Status.

5.7.2 Port Mirror

Port mirroring function allows the sending of a copy of network packets seen on one switch port to a
network monitoring connection on another switch port. Port mirroring can be used to analyze and debug
data or diagnose errors on a network or to mirror either inbound or outbound traffic (or both).
There are no preset values in the Port Mirror. The displayed values do not represent the actual setting
values.
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018
5 Managing Switch
47