Concluding Steps - Fujitsu PRIMERGY TX1320 M4 Upgrade And Maintenance Manual

System board and components

14.7.1.4 Concluding steps

Ê Connect all cables to the system board.
I
For the cable plan, see chapter
Ê Install all remaining system board components as shown in the related
sections:
– M.2 SSD (if applicable): see section
page 288
– Dual microSD 64 GB Enterprise (if applicable): see section
Dual microSD 64GB Enterprise" on page
– Memory modules: see section
page 211.
I
Ensure that you reinstall each memory module in the slot it was
located before the replacement.
– Heat sinks: see section
– Expansion cards: see section
I
Ensure that you reinstall each card in the slots it was located before
the replacement.
Ê Install the corresponding HDD fan:
"Reassembling" on page 57
Ê
Ê Connect all external cables.
"Connecting the power cord" on page 60
Ê
"Switching on the server" on page 63
Ê
I
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the
message CPU has been changed.
This only indicates that the CPU configuration has been altered.
There is no technical problem.
Proceed as follows:
Ê Restart your server.
310
"Installing a memory module" on
"Installing the heat sink variant 1" on page
"Expansion cards" on page
"Fans" on page 163
Upgrade and Maintenance Manual
"Appendix B" on page
"Installing an M.2 SSD" on
296.
341.
"Installing the
229.
180.
TX1320 M4