Installing An Expansion Card; Concluding Steps - Fujitsu PRIMERGY TX1320 M4 Upgrade And Maintenance Manual

9.4.3.3

Installing an expansion card

Ê If applicable, install the slot bracket, see section
page 173.
Ê Install the expansion card, see section
page 181.
9.4.3.4

Concluding steps

"Reassembling" on page 57
Ê
Ê If applicable, connect external cables to the expansion card.
"Connecting the power cord" on page 60
Ê
"Switching on the server" on page 63
Ê
"Enabling replaced components in the BIOS" on page 82
Ê
Ê Inform the customer about changed WWN and MAC addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page
Ê After replacing a network controller in a server running Linux OS,
the NIC configuration file in a Linux and VMware environment" on page 86
"Updating expansion card firmware" on page 73
Ê
"Resuming BitLocker functionality" on page 87
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For more information, see section
settings recovery" on page
Ê If applicable, restore LAN teaming configurations, see
replacing/upgrading LAN controllers" on page
TX1320 M4
190.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing a slot bracket" on
"Installing the expansion card" on
"Note on network
"After
93.
88.
"Updating
191