Concluding Steps - Fujitsu PRIMERGY TX1320 M4 Upgrade And Maintenance Manual

Ê Fasten the four captive screws on the heat sink in a crossover pattern
(torque 6.0 Nm, not applicable for Japan) (1-4).
Ê Connect the CPU fan cable to the connector "FAN1" on the system board
(see arrow).

11.2.9 Concluding steps

"Reassembling" on page 57
Ê
"Connecting the power cord" on page 60
Ê
"Switching on the server" on page 63
Ê
I
When the system is powered on after a CPU has been replaced or
upgraded, the Global Error indicator will start flashing with the message
CPU has been changed.
This only indicates that the CPU configuration has been altered. There is
no technical problem.
Proceed as follows:
Ê Restart your server.
Ê As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
If a password is assigned, enter the password and press [Enter].
Ê Select the Save & Exit menu.
Ê Select Save Changes and Exit or Save Changes and Reset.
Ê Verify that the Global Error indicator stops flashing.
– If applicable, "Updating or recovering the BIOS and the iRMC S5" on
page 71
– "Resetting the error status after replacing memory modules or CPUs" on
page 78
– "Enabling replaced components in the BIOS" on page 82
– "Resuming BitLocker functionality" on page 87
TX1320 M4
Upgrade and Maintenance Manual
Processor (CPU)
231