Concluding Steps; Replacing The Irmc Microsd Card; Preliminary Steps - Fujitsu PRIMERGY TX1320 M4 Upgrade And Maintenance Manual

14.4.2.3 Concluding steps

"Reassembling" on page 57
Ê
"Connecting the power cord" on page 60
Ê
"Switching on the server" on page 63
Ê

14.4.3 Replacing the iRMC microSD card

Upgrade and Repair Unit
(URU)
Tools: a pair of side-cutting pliers

14.4.3.1 Preliminary steps

"Locating the defective server" on page 47
Ê
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
"Getting access to the component" on page 51
Ê
14.4.3.2 Replacing the iRMC microSD card
Ê Remove the defective iRMC microSD card, see section
iRMC microSD card" on page
V
CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
Ê Install the new iRMC microSD card, see section
microSD card" on page
TX1320 M4
286.
284.
Upgrade and Maintenance Manual
System board and components
Hardware: 5 minutes
"Removing the
"Installing the iRMC
287