DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual page 128

Icon Parameter
Stop-Time for direction change
The waiting time at the turning points (for
example for a change of sewing direction)
is set at this point. A short waiting time in
milliseconds should ensure consistent
seam quality (ornamental-stitch bartack).
Stitch length default
If this function is active, the same stitch
length is used for the bartack as the one
set in Manual mode. If this function is
deactivated, a custom input can be
entered.
Speed in bartack
Single stitches per pedal
If this function is activated, each stitch in
the bartack can be sewn individually by
pressing the pedal. This function can only
be used meaningfully if the speed is set
very low for the bartack.
Needle thread tension default
If this function is active, the same needle
thread tension is used for the bartack as
the one set in Manual mode. If this func-
tion is deactivated, a custom input can be
entered.
126
Programming Commander DELTA
Setting
Value range
0000 – 1000 [ms]
On/Off
Stitch length of stitches
forward
Value range
01.0 - 12.0 [mm]
(depending on subclass)
Stitch length of backwards
stitches
Value range
01.0 - 12.0 [mm]
(depending on subclass)
Value range
0000 - 2000
Value range
On/Off
Value range
On/Off
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019