DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual page 104

Icon Parameter
Stitch length default
If this function is active, the same stitch length is
used for the bartack as the one set in Manual
mode. If this function is deactivated, a custom
input can be entered.
Speed in bartack
Single stitches per pedal
If this function is activated, each stitch in the
bartack can be sewn individually by pressing the
pedal. This function can only be used meaning-
fully if the speed is set very low for the bartack.
Needle thread tension default
If this function is active, the same needle thread
tension is used for the bartack as the one set in
Manual mode. If this function is deactivated, a
custom input can be entered.
Catch bartack
To ensure a safe sewing start and complete sew-
ing of the start bartack, an additional bartack can
precede the start bartack.
Only the number of forward and backward
stitches can be selected. The stitch length can-
not be set individually – it corresponds to the
stitch length of the normal start bartack.
102
Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Setting
On/Off
Stitch length of
stitches forward
Value range
01.0 - 12.0 [mm]
(depending on subclass)
Stitch length of
backwards stitches
Value range
01.0 - 12.0 [mm]
(depending on subclass)
Value range
0000 - 2000
Value range
On/Off
Value range
On/Off
On/Off
Number of stitches
backwards
Value range
01 - 50
Number of stitches
forward
Value range
01 - 50
Number of bartack
sections
Value range
01 - 10