DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual page 100

Icon Parameter
Stitch length default
If this function is active, the same stitch
length is used for the bartack as the one
set in Manual mode. If this function is
deactivated, a custom input can be
entered.
Speed in bartack
Single stitches per pedal
If this function is activated, each stitch
in the bartack can be sewn individually
by pressing the pedal. This function can
only be used meaningfully if the speed
is set very low for the bartack.
Needle thread tension default
If this function is active, the same
needle thread tension is used for the
bartack as the one set in Manual mode.
If this function is deactivated, a custom
input can be entered.
Catch bartack
To ensure a safe sewing start and
complete sewing of the start bartack, an
additional bartack can precede the start
bartack.
Only the number of forward and
backward stitches can be selected.
The stitch length cannot be set individu-
ally – it corresponds to the stitch length
of the normal start bartack.
98
Programming Commander DELTA
Setting
On/Off
Stitch length of stitches
forward
Value range
01.0 - 12.0 [mm]
(depending on subclass)
Stitch length of backwards
stitches
Value range
01.0 - 12.0 [mm]
(depending on subclass)
Value range
0000 - 2000
Value range
On/Off
Value range
On/Off
On/Off
Number of stitches backwards
Value range
01 - 50
Number of stitches forward
Value range
01 - 50
Number of bartack sections
Value range
01 10
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019