DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual page 89

Programming Commander DELTA
Menu item
Software / Stitch Counter
In Software mode, the bobbin is
monitored by the software based on
the number of stitches sewn.
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Setting option 1
Counter Type
4 different counters can be applied.
The following 3 subitems can be set
for each of the counters.
Counter value
Bobbin supply capacity in stitches.
This is a very variable value, which
depends on the size of the bobbin
and the thickness of the thread.
Sewing stop
Sewing stops and a notice is shown
on the display when the bobbin is
detected to be nearly empty. If the
parameter is not activated, only the
LEDs on the machine arm give a
warning if the bobbin is empty.
Sewing foot lower position Value range
Reset necessary
It is only possible to resume sewing
after changing the bobbin and
confirming the message on the
control panel.
Setting option 2
Value range
A/B/C/D
Value range
00000 - 99999
Value range
On/Off
On/Off
Value range
On/Off
87