DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual page 51

Operation
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Condition Processes
Start bartack • Press the pedal forwards (position +1) and keep it
and sew there.
Machine sews a start bartack (if specified).
Afterwards, the machine continues to sew - with
increasing speed the further forward the pedal is
pressed.
In the middle of the seam
Stop sewing • Release the pedal (position 0).
Machine stops. Depending on the setting, sewing
feet and needle are up / down.
Continue the • Press the pedal forwards (position +1)
sewing process Machine continues to sew - with increasing speed
(after releasing the further forward the pedal is pressed.
the pedal)
Sew over thicker • Switch on the elevated sewing foot stroke with
parts of the the knee button ( p. 44).
material
Change the
• Activate the 2
stitch length
the push button panel ( p. 45).
Increase the • Activate additional thread tension using the button
thread tension on the push button panel ( p. 45).
Sew an interme- • Sew backwards with stitch regulator ( p. 44) or
diate bartack activate backwards sewing using the button on the
push button panel ( p. 45).
At seam end
Finish the seam • Press the pedal fully back (position -2) and keep it
and remove the there.
sewing material End bartack is sewn, and thread is cut (if set).
Machine stops.
Needle is up. Sewing feet up.
• Remove the sewing material.
nd
stitch length using the button on
49