DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual page 86

Icon Parameter
Gap
Value for the gap between the motor driven
edge guide and the needle (factoring in the
defined safety distance to the sewing feet).
Correction speed effect
Correction speed effect
Stitch length
Needle thread tension
Sewing foot pressure
Material thickness detection
Material thickness detection
Sewing foot stroke
Stitch length
84
Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
Setting
Value range
1.0 - 45.0
(depends on the sewing
equipment)
Value range
On/Off
(see  p. 88)
The stitch length changes
slightly depending on the
speed. For this reason, the
stitch length can be adjusted
at different speeds by the
software.
Depending on the speed, the
needle thread tension can be
adjusted at different speeds
by the software.
Depending on the speed, the
sewing foot pressure can be
adjusted at different speeds
by the software.
Value range
On/Off
(see  p. 92)
The sewing foot stroke can be
adjusted to different material
thicknesses by the software.
The stitch length changes
slightly depending on the
material thickness. For this
reason, the stitch length can
be adjusted to different
material thicknesses by the
software.