Authorizations As Default Technician - DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual

Programming Commander DELTA
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
5.4.1

Authorizations as Default Technician

The factory setting for the Default Technician requires
that the technician enter their username and password (techni-
cian, 25483) to log in. If selecting User Management as a
Default Technician ( p. 61), you will be presented with
the following interface:
Fig. 42: Authorizations as Default Technician
①
(1) - Tab for roles and users
(2) - List of roles/users
On the left-hand side, you can select between the tabs (1) reserved
for roles ( p. 66) and users ( p. 70). Detailed explanations
are provided further below. To the right of the tabs you will find
the list (2) of created roles / users - varying with the tab (1) you
selected. On the far right, you will find the settings (3) associated
with the role/user you selected.
Explanation of role and user
Roll
A role defines which authorizations
are permitted or forbidden.
It is possible to assign more than
one role to a single user.
You need to be a user to log in;
you cannot log in using a role.
②
(3) - Settings for
roles/users
User
You can log in as a user.
A user can be assigned one or
several roles - this is how they
receive their authorizations.
③
65