Setting The Segment End Parameters - DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual

Programming Commander DELTA
Icon Parameter
Parameter Seam End
Sewing foot lift after trim
Height of sewing foot lift after
trim
Thread trimmer
End bartack parameters
Bartack at seam end
Number of stitches backwards
Number of stitches forward
Number of bartack sections
A bartack consists of several sections. If the
sewing direction is changed, a new section is
started. The number of sections in a bartack can
be set here.
Stop-Time for direction change
The waiting time at the turning points (for exam-
ple for a change of sewing direction) is set at this
point. A short waiting time in milliseconds should
ensure consistent seam quality
(ornamental-stitch bartack).
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
5.6.6

Setting the Segment End parameters

There are various options for setting the parameters at the
segment end. The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Setting
Value range
On/Off
Value range
00 – 20 [mm]
(depending on subclass)
Value range
On/Off
Value range
On/Off
Value range
01 - 50
Value range
01 - 50
Value range
01 - 99
Value range
0000 – 1000 [ms]
101