Chapter 5: Installing The Switch On A Table; Figure 39: Installing The Bumper Feet - Allied Telesis AT-x930-28GTX Installation Manual

Chapter 5
Installing the Switch on a Table
To install the switch on a table, perform the following procedure:
Warning
Switches should not be stacked on a table or desktop because that
could present a personal safety hazard if you need to move or
replace switches.  E91
Warning
The switch is heavy. Always ask for assistance when moving or
lifting the device so as to avoid injuring yourself or damaging the
equipment.
1. Review the procedure in "Choosing a Site for the Switch" on page 61 to
verify that the selected site is suitable for the unit.
2. Check to be sure that the table is strong enough to support the weight
of the switch.
3. Check to be sure that all of the appropriate components are included in
the shipping container. Refer to "Unpacking the Switch" on page 62.
4. Place the switch upside down on a level, secure table or desk.
5. Install the seven bumper feet to the bottom of the switch, as shown in
Figure 39.
Three bumper feet should be installed along the front edge of the
bottom panel and four feet along the rear edge.
Figure 39. Installing the Bumper Feet
87