Connecting The Wiring Harness To The Valves; Assembling The Valve Actuator To The Manifold Valve; Connecting The Electrical Connectors For The Section Valve - Toro Multi Pro 1750 Installation Instructions Manual

Assembling the Valve Actuator to the
Manifold Valve
Perform this procedure if you removed the valve actuator (s)
to install the hose assemblies onto the manifold valve(s).
1. Align valve actuator that you identified in step
Removing the Valve Actuators (page 25)
manifold valve position shown in
2. Secure the valve actuator to the manifold valve with the
retainer that you removed in step
Valve Actuators (page
11
Connecting the Wiring
Harness to the Valves
No Parts Required
Connecting the Electrical Connectors
for the Section Valve
1. Connect the 3-pin valve harness labeled
into the 3-socket connector for the left spray
VALVE
valve (Figure 56).
1
with the
Figure 51.
2 of Removing the
25).
LEFT SPRAY
of
1. 3-socket valve harness
(right spray valve)
2. 3-socket valve harness
(center spray valve)
3. 3-socket valve harness
(left spray valve)
2. Connect the 3-pin valve harness labeled
into the 3-socket connector for the center spray
VALVE
valve (Figure
3. Connect the 3-pin valve harness labeled
into the 3-socket connector for the right spray
VALVE
valve (Figure
27
Figure 56
4. 3-pin valve harness (right
spray valve)
5. 3-pin valve harness
(center spray valve)
6. 3-pin valve harness (left
spray valve)
56).
56).
CENTER SPRAY
RIGHT SPRAY