Cleaning / Changing The Moistening Sponge - FP PostBase Vision Reference Manual

Spacer ring
16.9.3

Cleaning / changing the moistening sponge

The sponge for moistening the envelope flaps should be cleaned regularly (e.g.
always after a weekend). Check the condition of the sponge and replace it if
exhausted. We recommend always keeping a new sponge in reserve.
Warning! Electrical hazards due to short circuits.
Be extremely careful when handling the sealant tank and tray to prevent spilling
any liquids. Make sure not to wetten any parts connected to the mains. If this
should happen, immediately pull the power plugs. Have the PostBase Vision
mailing system checked by the Customer Support before using it again.
Increased moistening
Lug
• Position the spacer ring so that the teeth
• Insert the sealant tray into the housing until
• Insert sealant tank into the housing with the
• Switch the mailing system off.
3 seconds
are facing up and the lug on the tray is
placed between the guides.
it clicks into place (see page 143).
cover downward. Close the flap. (See
page 139.)
Maintenance and care
141