FP PostBase Vision Reference Manual page 26

26
PostBase Vision
Connectivity settings
Default settings for an Ethernet connection
are stored for contacting the FP infrastruc-
ture. Establishing the connection should run
seamlessly with these settings.
To test the connection to the FP infrastruc-
ture with this default setting:
• Tap the C
ONTINUE
If no connection is established, the "Connec-
tivity Settings" must be adjusted:
• Tap C to open the entry wizard for
HANGE
setting up the network connection.
• First select the desired connection type.
• Confirm the selection and continue with the
C button.
ONTINUE
• Set the appropriate parameters for the net-
work step by step. If necessary, ask your
network administrator.
The "Connectivity Settings" overview
shows and explains the possible settings
(see page 115).
Caution! During the further course of instal-
lation, the PostBase Vision may start up
multiple times. Do not disconnect the
PostBase Vision from the power supply.
button.