Reset To Factory Default Settings By External Push Button; Default Factory Settings Of The Router; How To Set The Factory Settings; Ip Routing - Weidmuller IE-SR-2GT-LAN Manual

8. Reset to factory default settings by external push button

By pressing the push button "Factory Default" the security Router can be reset at any time and regardless of
the configuration to the default settings (factory settings).

How to set the factory settings:

1. Power off the Router
2. Press the button „Factory Default" and keep it hold down
3. Power on the Router and keeping button „Factory Default" pressed while Router is booting
4. Release button „Factory Default" when Power LED starts flashing fast (around 10 seconds after power on)
5. Wait until Power LED is glowing constantly green
 Now the Router is ready to run with factory default settings.

Default factory settings of the Router:

Language:
Operation mode :
IP address LAN port:
Subnet mask:
NAT (Masquerading) on LAN port: Not activated
IP address WAN port:
Subnet mask:
NAT (Masquerading) on WAN port: Not activated
Default gateway:
DNS:
Firewall (Packet filter):

IP routing

SNMP / DHCP / DNS
VPN:
Data prioritization
Only model IE-SR-2GT-UMTS/3G
3G Modem
Copyright © 2013 Weidmüller Interface GmbH & Co. KG
All rights reserved. Reproduction without permission is prohibited.
Englisch user interface
IP Router
192.168.1.110 (static value)
255.255.255.0
192.168.2.110 (static value)
255.255.255.0
No entry
DNS relay not activated
By default, data traffic in both directions between LAN and WAN is
allowed on both level Layer 2 and Layer 3. For that the packet filter
contains two default rules, called "Allow_L2" and "Allow_L3" (allow traffic
at Layer 2 and 3) which allows as "white lists" all network traffic.
 No static routes
 Dynamic routing (OSPF, RIP) disabled
Disabled
Disabled
Disabled
Disabled
17 / 103