Dip Switch Settings; Led Indicators - Weidmuller IE-SW-VL16-16TX Hardware Installation Manual

DIP Switch Settings

IE-SW-VL16 Series DIP Switches
ON: Enables the corresponding PORT Alarm. If the port's link fails, the relay
will form an open circuit and the fault LED will light up.
Off: Disables the corresponding PORT Alarm. The relay will form a closed
circuit and the Fault LED will never light up.
Note that the switches of the IE-SW-VL16 Series has 18 DIP switches in total;
2 DIP switches are reserved.

LED Indicators

The front panel of Ethernet Switch contains several LED indicators. The
function of each LED is described in the table below.
LED Color State
On
PWR1 AMBER
Off
On
PWR2 AMBER
Off
On
FAULT RED
Off
On
Blinking Data is being transmitted at 10 Mbps
10M GREEN
Off
On
100M
Blinking Data is being transmitted at 100 Mbps
GREEN
(TP)
Off
On
100M
Blinking Data is being transmitted at 100 Mbps
GREEN
(FX)
Off
Description
Power is being supplied to power input
PWR1
Power is not being supplied to power input
PWR1
Power is being supplied to power input
PWR2
Power is not being supplied to power input
PWR2
When the corresponding PORT alarm is
enabled, and the port's link is inactive.
When the corresponding PORT alarm is
enabled and the port's link is active, or
when the corresponding PORT alarm is
disabled.
TP port's 10 Mbps link is active
TP Port's 10 Mbps link is inactive
TP port's 100 Mbps link is active
100BaseTX Port's link is inactive
FX port's 100 Mbps is active
100BaseFX port is inactive
- 11 -