Weidmuller IE-SR-2GT-LAN Manual page 83

Configure below described entries in the section Dynamic routing of the menu:
 Configure the below described parameters for all Routers 1, 2 and 3
LAN: ● Type:
● Simple password:
● Active interface:
WAN: ● Type:
● Simple password:
● Active interface:
Note:
You should always use the same value for "Type" on both ports (LAN and WAN). For example if you leave
Type=disabled on LAN port and you activate only the parameters Type=RIP and Active interface=set on WAN port, then
the Router will not announce (outgoing WAN port) the configured network connected to its LAN port.
The checkbox "Redistribute static routes" can be left blank because we don't use static routes. As log level you can
chose how detailed information about RIP will be shown in the menu Eventlog.
►Click button "Apply settings" to activate the new settings.
Figure A5-2: Configured dynamic IP routing
Copyright © 2013 Weidmüller Interface GmbH & Co. KG
All rights reserved. Reproduction without permission is prohibited.
Select "RIP"
Free text
Note: If there are several Routers with activated RIP but only the Routers 1, 2 and 3
should exchange their routing tables, then you have to use the same password for
each Router.
Activate the checkbox if the Router shall send the routing table to the LAN port (to
other Routers)
Select "RIP"
 see explanation above
Activate the checkbox if the Router shall send the routing table
to the WAN port (to other Routers)
83 / 103